Pin16

P0979

Shift Solenoid "C" Control Circuit Low

Severity
High
Driving
Drive only to a garage

The control circuit for shift solenoid "C" is reading low - typically shorted to earth or open circuit. The module cannot drive the solenoid, so the gears that depend on it are unavailable and the transmission will hold a single gear.

Possible causes

What you might notice

What to check, in order

  1. Read all codes first. Several solenoid codes at once point at the case connector or the internal harness rather than at several failed solenoids.
  2. Disconnect at the case connector and check whether the low reading persists at the harness side.
  3. Pull the case connector and look for fluid ingress and corroded pins.
  4. Measure the solenoid winding resistance against specification.
  5. Check the fluid level and condition while the vehicle is raised.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits