Pin16

P0956

Auto Shift Manual Mode Circuit Range/Performance

Severity
Low
Driving
No driving restriction

The auto shift manual mode circuit is answering but its reading is implausible - manual mode reported when the selector is not there, or a mode state that does not match the selector position. Usually a worn or contaminated selector rather than a wiring fault.

Possible causes

What you might notice

What to check, in order

  1. Move the selector slowly between modes while watching the reported state. Look for a position that reads ambiguously - the classic sign of worn contacts.
  2. Inspect the selector for spilled drink.
  3. Check the gate mechanism for wear and free play.
  4. Inspect the connector for a partial short between adjacent pins.
  5. Check for other selector codes stored alongside.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits