Pin16

P0906

Gate Select Position Circuit Low

Severity
High
Driving
Drive only to a garage

The gate select position signal is stuck low - typically shorted to earth or open circuit. The module has no usable indication of which gear pair the selector shaft has moved to, so it will refuse to complete a gear change.

Possible causes

What you might notice

What to check, in order

  1. Unplug the sensor and check whether the low reading persists at the harness. If it does, the wiring is at fault rather than the sensor.
  2. Check the reference voltage and earth - a lost earth commonly drives a signal high, so a high reading is not always a shorted wire.
  3. Inspect the connector for corrosion and water.
  4. Look for other codes sharing the same reference circuit before condemning this sensor.
  5. Run the position calibration after any repair.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits