Pin16

P0925

Gear Shift Reverse Actuator Circuit Range/Performance

Severity
High
Driving
Drive only to a garage

The gear shift reverse actuator circuit is electrically sound but the actuator is not performing as expected - slow, weak, or not reaching its position. The cause is mechanical or hydraulic rather than electrical.

Possible causes

What you might notice

What to check, in order

  1. Check hydraulic pressure first on a hydraulically actuated system.
  2. Run the calibration procedure.
  3. Watch commanded against actual position through a full sweep.
  4. Check the hydraulic fluid level and condition.
  5. Consider gearbox wear if engagement grinds rather than simply being slow.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits