Pin16

P0911

Gate Select Actuator Circuit Range/Performance

Severity
High
Driving
Drive only to a garage

The gate select actuator circuit is electrically sound but the actuator is not performing as expected - slow to move, not reaching position, or drawing the wrong current. The problem is mechanical or hydraulic rather than electrical.

Possible causes

What you might notice

What to check, in order

  1. Check hydraulic pressure first if the system is hydraulically actuated. A slow actuator is far more often a pressure problem than a failed motor.
  2. Run the calibration procedure.
  3. Watch commanded against actual position on the live data screen through a full sweep.
  4. Check the hydraulic fluid level and condition.
  5. Check the wiring for high resistance before replacing the actuator.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits