Pin16

P0935

Hydraulic Pressure Sensor Circuit High

Severity
High
Driving
Drive only to a garage

The hydraulic pressure signal is stuck high - typically shorted to voltage or a lost earth. Without a usable pressure reading the module will not attempt gear changes it cannot guarantee, so the car may refuse to move.

Possible causes

What you might notice

What to check, in order

  1. Check the hydraulic fluid level and look for leaks before assuming an electrical fault. Genuinely low pressure is a real fault, not a sensor problem.
  2. Unplug the sensor and check whether the high reading persists at the harness.
  3. Check the reference voltage and earth.
  4. Inspect the connector for corrosion and fluid contamination.
  5. Read all codes for pump or pressure unit faults alongside.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits