Pin16

P0839

Four Wheel Drive (4WD) Switch Circuit High

Severity
Medium
Driving
Drivable — book it in

The four-wheel drive switch signal is stuck high - typically shorted to voltage or open circuit. The module has no usable indication of the requested drive mode and will default to a safe one.

Possible causes

What you might notice

What to check, in order

  1. Unplug the switch and check whether the high reading persists at the harness.
  2. Inspect the connector for corrosion and water.
  3. Follow the harness under the vehicle looking for chafe and impact damage.
  4. Check the switch continuity in each position against specification.
  5. Check for other transfer case codes.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits