Pin16

P0834

Clutch Pedal Switch "B" Circuit Low

Severity
Medium
Driving
Drivable — book it in

The clutch pedal switch "B" signal is stuck low - typically shorted to earth, or the switch stuck in one state. The module cannot tell whether the clutch pedal is pressed, so starting, cruise control and stop-start may all behave unexpectedly.

Possible causes

What you might notice

What to check, in order

  1. Watch the switch "B" state while pressing and releasing the pedal. A reading that never changes confirms the fault.
  2. Unplug the switch and check whether the low reading persists at the harness. If it does, the wiring is at fault rather than the switch.
  3. Check the adjustment before condemning the switch - a switch the pedal never reaches reads exactly like a failed one.
  4. Compare against the other clutch switch, which should still behave normally.
  5. Ask whether an aftermarket alarm or immobiliser was fitted, since these are commonly wired into the clutch switch circuit.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits