Pin16

P2772

Four Wheel Drive (4WD) Low Switch Circuit Range/Performance

Severity
Medium
Driving
Drivable — book it in

The four-wheel drive low range switch is answering but its reading is not plausible - two positions reading the same, or a position reported that the selector is not in. Worn contacts or a linkage not moving the switch fully are the usual reasons.

Possible causes

What you might notice

What to check, in order

  1. Move the selector slowly through every position while watching the reported state, looking for a position that reads ambiguously.
  2. Check the switch adjustment and its linkage for wear.
  3. Confirm the actuator completes its travel.
  4. Inspect the connector for corrosion and for a partial short between adjacent pins.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits