Pin16

P2762

Torque Converter Clutch Pressure Control Solenoid Control Circuit Range/Performance

Severity
Medium
Driving
Drivable — book it in

The torque converter clutch pressure solenoid circuit is connected but the current drawn does not match what was commanded - usually a worn solenoid, high resistance in the wiring, or debris restricting its movement.

Possible causes

What you might notice

What to check, in order

  1. Measure the solenoid resistance at the case connector against specification.
  2. Perform a voltage drop test on the circuit.
  3. Check the fluid level and condition first. It is the cheapest check and it explains more transmission complaints than every electrical fault combined.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits