Pin16

P0725

Engine Speed Input Circuit

Severity
High
Driving
Drive only to a garage

A fault in the circuit for the engine speed input circuit, which tells the module engine speed, as reported to the transmission module. That matters because the module needs engine speed to time shifts and to manage the torque converter. Without it the module cannot verify what the transmission is doing, so it will usually stop shifting normally and hold a single gear.

Possible causes

What you might notice

What to check, in order

  1. Watch the speed readings on the live data screen while driving. Input and output speed should track each other in a fixed ratio in each gear; one that reads zero or jumps about names itself.
  2. Inspect the sensor tip for a coating of metal filings. Debris here is not just the fault - it is evidence of internal wear that will need addressing.
  3. Check the connector and wiring at the sensor for corrosion and chafing.
  4. Check the fluid level and condition.
  5. If the sensor is accessible, measure its resistance against specification.
  6. Where the sensor is internal, eliminate the external wiring and the case connector before dropping the pan.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits