Pin16

P0798

Pressure Control Solenoid "C" Electrical

Severity
High
Driving
Drive only to a garage

An electrical fault in the circuit for pressure control solenoid "C" - an open winding, a short, or resistance outside specification. This is a circuit complaint rather than a hydraulic one: the module cannot drive the solenoid at all, so it falls back to a failsafe pressure and usually holds one gear.

Possible causes

What you might notice

What to check, in order

  1. Read all transmission codes first. Several solenoid electrical codes at once point at the case connector or the internal harness rather than at several failed solenoids - that single observation saves a lot of unnecessary work.
  2. Pull the transmission case connector and look for fluid inside it. Fluid wicking up the harness corrodes the pins and can reach the control module itself.
  3. Measure the solenoid winding resistance at the case connector against specification.
  4. Check the wiring between the module and the transmission for chafing.
  5. Check the fluid level and condition while the vehicle is raised.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits