Pin16

P0780

Shift Error

Severity
High
Driving
Drive only to a garage

The transmission attempted a shift and it did not go as commanded, without the module identifying which shift or which component. It is a general complaint that the shift did not complete properly - too slow, incomplete, or not happening at all.

Possible causes

What you might notice

What to check, in order

  1. Check the fluid level and condition first.
  2. Read all stored codes. A specific shift code or a solenoid code alongside this one identifies the actual problem.
  3. Note which shifts are affected and whether it is consistent.
  4. Check whether the transmission has ever had a fluid and filter service.
  5. A pressure test is the way to separate hydraulic problems from mechanical wear.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits