Pin16

P2112

Throttle Actuator Control System - Stuck Closed

Severity
Critical
Driving
Drive only to a garage

The throttle plate is stuck closed. The module commanded it open and it did not move, so the engine can only idle - the car will barely move, if at all. Carbon seizing the plate is again the usual reason.

Possible causes

What you might notice

What to check, in order

  1. The car may be unable to move under its own power. Arrange recovery rather than trying to coax it along.
  2. Remove and inspect the throttle body for carbon and for anything jamming the plate.
  3. Check the motor is being driven electrically before assuming a mechanical jam.
  4. Run the throttle relearn procedure after any cleaning or replacement.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits