Pin16

P0554

Power Steering Pressure Sensor/Switch Circuit Intermittent

Severity
Medium
Driving
Drivable — book it in

The power steering pressure signal is dropping out intermittently. The engine may stall occasionally while parking and behave perfectly the rest of the time.

Possible causes

What you might notice

What to check, in order

  1. Check the power steering fluid level and look for leaks. A hydraulic pump low on fluid loads the engine unpredictably and whines while doing it.
  2. Watch the sensor reading while someone turns the steering from lock to lock with the engine idling - the pressure should rise clearly.
  3. Inspect the connector for corrosion and fluid contamination.
  4. Check the reference voltage and earth at the sensor.
  5. Note what this sensor is for: it tells the module to raise idle speed when the steering pump loads the engine. That is why the symptom is stalling while parking rather than anything to do with the steering itself.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits