Pin16

P0502

Vehicle Speed Sensor "A" Circuit Low Input

Severity
Medium
Driving
Drivable — book it in

The vehicle speed sensor "A" signal is low. A signal that is absent, weak or jumping usually means wiring or a mechanical problem at the sensor rather than a module fault.

Possible causes

What you might notice

What to check, in order

  1. Inspect the connector for water and corrosion - this is the most common cause on an exposed sensor.
  2. Watch the live speed value while driving slowly over a rough surface; a dropout points at wiring rather than the sensor.
  3. Remove the sensor and check the tip for metal debris, which is common on a sensor reading a steel ring.
  4. Check the sensor's ground.
  5. Replace the sensor once the wiring and mounting have been eliminated.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits