Pin16

P0190

Fuel Rail Pressure Sensor Circuit

Severity
High
Driving
Drive only to a garage

A fault in the fuel rail pressure sensor circuit. This sensor tells the module the pressure in the high pressure fuel rail, and the module controls fuelling by that figure - injector opening times are calculated from it, so without it the module cannot know how much fuel an injection actually delivers. Most engines respond by cutting power sharply or refusing to run.

Possible causes

What you might notice

What to check, in order

  1. Read all codes before deciding this is the sensor. Fuel delivery and pressure regulation codes stored alongside usually mean the sensor is telling the truth about a supply problem, and replacing it would fix nothing.
  2. Compare commanded rail pressure against actual on live data, at idle and under load. A system that holds pressure at idle and loses it under load is worn rather than broken.
  3. Check the low pressure supply and the filter first. Most rail pressure faults start upstream, and the filter is the cheapest thing in the chain.
  4. Inspect the sensor connector for corrosion and for damaged pins.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits