Pin16

P0146

O2 Sensor Circuit No Activity Detected (Bank 1 Sensor 3)

Severity
Low
Driving
Drivable — book it in

No activity is being seen from oxygen sensor 3 on bank 1, downstream of the converter. The signal is flat rather than incorrect, which points at an open circuit, a dead sensor, or a failed heater keeping the sensor below operating temperature.

Possible causes

What you might notice

What to check, in order

  1. Check the connector and the heater circuit fuse first.
  2. Inspect the wiring under the car - these leads are exposed to salt and stone damage.
  3. Look for a heater code stored alongside this one, which would identify the cause.
  4. Replace the sensor once wiring and fuse are eliminated.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits