Pin16

P0102

Mass or Volume Air Flow Circuit Low Input

Severity
Medium
Driving
Drivable — book it in

The mass airflow sensor signal is too low. The module has a valid range for this sensor and the reading sits outside it, which points at a wiring problem, a leak, or a failed sensor rather than a subtle calibration drift.

Possible causes

What you might notice

What to check, in order

  1. Inspect the connector and wiring at the sensor, including for chafing where the harness passes the engine.
  2. Check the intake ducting for splits, particularly on the underside where cracks are easy to miss.
  3. Clean the sensor element with the correct cleaner.
  4. Check the air filter.
  5. Compare live airflow readings against specification before replacing the sensor.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits