Pin16

P2262

Turbo Boost Pressure Not Detected - Mechanical

Severity
Medium
Driving
Drive only to a garage

The module commanded boost and measured none. The circuits check out, so this is mechanical: either the charger is not producing pressure, or the pressure is escaping before it reaches the engine. On a modern turbo diesel a split intercooler pipe is a far more likely explanation than a failed turbocharger.

Possible causes

What you might notice

What to check, in order

  1. Check every boost hose and intercooler pipe for splits and loose clamps. This is the single most common cause, it is visible, and it costs almost nothing to fix.
  2. Check the air filter - a neglected filter restricts intake air and produces these codes.
  3. On a diesel used mainly for short trips, suspect the variable-vane mechanism sticking with soot. A long run at higher revs sometimes frees it and is worth trying before spending.
  4. Check the wastegate or bypass valve moves freely.
  5. Watch commanded against actual boost on the live data screen through an acceleration.
  6. Suspect the turbo itself last. It is by far the most expensive item here and by far the least likely cause.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits