Pin16

P2208

NOx Sensor Heater Sense Circuit (Bank 1)

Severity
Medium
Driving
Drive only to a garage

A fault in the NOx sensor heater sense circuit on bank 1. This is the feedback line the module uses to confirm the heater actually drew current when it was switched on.

Possible causes

What you might notice

What to check, in order

  1. Check the fuse for the heater circuit before anything else.
  2. Inspect the connector for corrosion and heat damage.
  3. Measure the heater element resistance against specification.
  4. Check the wiring where it runs along the exhaust.
  5. Note that the heater is usually integral to the sensor. If the element has failed, the sensor is the repair - so eliminate the wiring and fuse first, because the sensor is expensive.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits