Pin16

P0668

PCM/ECM/TCM Internal Temperature Sensor Circuit Low

Severity
Medium
Driving
Drivable — book it in

The module's internal temperature signal is stuck low - typically an internal circuit fault, or a genuinely very low reading. Since this sensor is inside the module, the wiring you can reach is not the issue; what can be checked is whether the module is genuinely being overheated.

Possible causes

What you might notice

What to check, in order

  1. Check whether the module is actually hot. Feel its casing after a drive - a module too hot to hold comfortably is telling the truth.
  2. Read all codes. A shorted output stored alongside would explain genuine heating.
  3. Check the supply voltage and the connector before concluding the module has failed.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits