Pin16

P0466

EVAP Purge Flow Sensor Circuit Range/Performance

Severity
Low
Driving
No driving restriction

The EVAP purge flow sensor is answering but the flow it reports does not match what the purge valve was commanded to do. A blocked line and a stuck valve both produce this with a good sensor.

Possible causes

What you might notice

What to check, in order

  1. Read all codes. Purge flow codes alongside this one suggest the flow really is wrong and the sensor is reporting correctly.
  2. Check the fuel cap first. A loose, damaged or missing cap is the single most common cause of EVAP faults and costs nothing to check.
  3. Inspect the connector for corrosion and water - these sensors are mounted underneath and take constant road spray.
  4. Check the sensing hose for splits, kinks and blockage.
  5. Check the reference voltage and earth at the sensor.
  6. Note that EVAP monitors run only in particular conditions of fuel level, temperature and time since start, so confirming a repair can take several journeys.

Read this code from your own car

Plug an ELM327 adapter into the OBD-II port under the dashboard. Pin16 reads every stored, pending and permanent code, explains each one like this page does — offline, with no account — and shows what the car recorded when the fault was set.

Get Pin16 on Google Play

Where this code sits